Swapping X and Y axis : what about engraving ?
On my Hx3040, Y is the "fast" axis.
Is there a way to scan using Y axis instead of X for engraving ?
Does it work when you increase the y.speed and y.accel?
No, I tried y.speed 2000 and y.accel 2000 (I had no y.accel in the config.txt before), still the head moves left/right instead of up/down.
Is there a part of the firmware that compares x.speed and y.speed to choose which axis is the best for engraving ?
On the NewlyDraw software, one could choose between up/down and left/right.
I thought it would be a job for Visicut, not for the firmware ?
Thanks for your help
RE: Swapping X and Y axis : what about engraving ? - Added by jaap almost 9 years ago
It's not in the firmware. Engraving direction is defined in the printer driver and Visicut. At the moment, you cannot change it (unless you edit the software).