LAOS - Laser Open Source

2014-03-31

14:13 LAOS Laser Discussion and support: RE: 4 point beam ?

Very intersesting !
How can you tell between rectangular TEM11 and circular TEM02 ?
An interesting picture there, w...

09:08 LAOS Laser Discussion and support: RE: 4 point beam ?

Thanks Peter,
I tried to realigne the mirrors because the laser was getting less and less efficient at cutting. Th...

2014-03-29

04:15 LAOS Laser Discussion and support: 4 point beam ?

Hi,
I tried to re align the mirror on my HX3040, but it seems to me that what I get on the cardboard is a bit stra...

2014-03-06

10:54 LAOS Laser Discussion and support: RE: Strange behavior after panel installation

Hi,
Thanks for your answer. I tried to unplug the panel and disable it in config.txt, but the problem remained.
But...

2014-03-05

16:00 LAOS Laser Discussion and support: Strange behavior after panel installation

Hi,
I cut a panel for my HX3040, based on the one for the LS3020 (Thanks for that too !)
!Hx3040Pannel.jpg!
Now,...

2014-02-27

11:27 LAOS Laser Discussion and support: RE: Swapping X and Y axis : what about engraving ?

No, I tried y.speed 2000 and y.accel 2000 (I had no y.accel in the config.txt before), still the head moves left/righ...

09:46 LAOS Laser Discussion and support: Swapping X and Y axis : what about engraving ?

Hi,
On my Hx3040, Y is the "fast" axis.
Is there a way to scan using Y axis instead of X for engraving ?
Thanks

2014-02-26

19:11 LAOS Laser Discussion and support: RE: Homing

OK,
So here is my config.txt.
It works Ok, but I had to change the effect of the joystick (up was moving down, and ...

2014-02-13

15:53 LAOS Laser Discussion and support: RE: Homing

OK, my mistake :
I forgot to swap the pins for xhome and yhome in LaosMotion.cpp
Things run much better now...
Sti...

10:17 LAOS Laser Software development: RE: Simplecode ARC and SFTP

Hi,
I would also be interested in arc moves. I think that GRBL has it in its current version ?
It could make circle...