- Email: email@example.com
- Registered on: 2012-11-11
- Last connection: 2014-08-29
- LAOS Laser (Developer, 2012-11-14)
- 21:47 LAOS Laser Software development: RE: Random Laser ON at engrave
- I've had similar problems, and I think it is LaOS related rather than visicut. I've more or less got rid of it by red...
Been cutting/engraving fine for the last few months, but just in the last week have hit an issue. At some poi...
- 20:48 LAOS Laser Discussion and support: RE: Constant resets when i2c board is attached.
- One question, is debug enabled on the arduino sketch for the display? I had issues with the cutter not working if deb...
- 19:39 LAOS Laser Discussion and support: RE: Test LaserScript
- Fantastic work. Just installed the nightly of Visicut, upgrading from 1.5, and its already solved a few issues I was ...
- 10:04 LAOS Laser Discussion and support: RE: K40III
- This is what I bought:
Just make sure you get it the rig...
- 13:15 LAOS Laser Discussion and support: RE: K40III
- Oh, hugomeiland: I'll give that a try this weekend. It doesn't seem too bad to be honest. Managed to cut through 6mm ...
- 13:14 LAOS Laser Discussion and support: RE: K40III
- There was no way I could use the moshi software long enough for it to melt! It was barely plugged in enough to let me...
Also available in: Atom